Outwater Plastics Industries Inc.

& Architectural Products
Outwater Pays Brokerage Fees,
 Duty & GST on your Purchase.
   Conditions apply-see terms

Where The Pros Shop Since 1972

Railing & Fittings ® ARCHITECTURAL CABLE ASSEMBLIES Cable Assembly Care & Maintenance Now Available In 3 Cable Diameters: 1/8", 3/16" & 1/4" The protective chromium oxide film on the surface of stainless steel gives it superior corrosion resistance. Properly maintained stainless steel provides excellent luster, strength and durability. In most applications stainless steel won't rust or stain even after many years of service, but it's NOT rust or stain proof. When stainless comes in contact with chloride salts, sulfides or other rusting metals, it can discolor or even rust and corrode. With proper care and maintenance, however, stainless steel can remain beautiful and functional for years to come, even when it's exposed to marine environments, polluted surroundings, salted highways or anywhere it might be exposed to corrosive elements. · Clean stainless with soap and warm water. Never clean with mineral acids or bleaches. · Never leave stainless in contact with iron, steel or other metals. This can cause rust spots or corrosion. · Always remove stains or rust spots as soon as possible with either soap and water or a brass, silver, stainless or chrome cleaner. · Never use coarse abrasives like sandpaper or steel wool on stainless. Use synthetic Scotch pads instead. · Periodically inspect cable assemblies for proper tension and re-tension as necessary. This is important. · On outdoor cable installations, coat the inside of the QuickConnect®SS fittings with Fluid Film® Corrosion Preventative and keep end fittings covered with End Caps. This is especially important in hot and humid areas and coastal locations with salt air. Product Guidelines* Spacing: For railings, we recommend spacing the cables no more than 3 inches apart and placing posts or vertical members no more than 3 feet apart. Load: Frames must be built strong enough to support the cable loads of approximately 350 lbs. per cable. * Securly fasten all posts and cap rails. Carefully plan all termination and corner posts for proper clearance, positioning and maximum cable run lengths. All other posts should be sized as required for cap rail support strength or for code. Minimum Sizes for All Corner & End Posts 3-1/2" wide, 5-1/2" thick 4 x 6 WOOD 2" wide, 1" thick FLAT BAR 2" wide, 1/2" thick ANGLE IRON EXTRA STRONG PIPE 1-1/2" ID, 1-7/8" OD SQUARE TUBE 2" wide, 1/4" wall Cables can terminate or run through corner posts Single & Double Wood Posts** Single Pipe** Double Pipe Angle Iron Double Flat Bar **Offset drill holes at least 1/2" when crossing fittings in a single corner post. Click Here NOTE: Since building codes vary by state, county and city, these recommendations may not comply with code requirements in all areas. ALWAYS consult with your local building department before starting your project. Minimum order is $25.00 (Merchandise only). Orders less than this minimum will be billed as $25.00 plus shipping charges and tax, if applicable. railing & fittings, cable-rail, cable rail, cablerail, deck railing, railing system W-44 ARCHITECTURAL PRODUCTS BY OUTWATER L.L.C. · www.outwater.com CATALOG IS PRICED IN U.S. DOLLARS
Magnified View - Please use mouse to move page for easier readability
- 2016 Master Catalog